Data Sheet
FGSW-2620CS
Cost-effective Edge Network Connection Solution
The FGSW-2620CS provides 24 Fast Ethernet ports and 2 Gigabit Ethernet ports and offers wire-speed packet transfer performance without risks of packet loss. It is equipped with non-blocking 8.8Gbps backplane; greatly simplifies the tasks of upgrading your LAN for catering to increasing bandwidth demands. The high data throughput makes the FGSW-2620CS ideal for most Gigabit environments, especially upgrading network to a Gigabit environment.
Advanced and Friendly Web-Based Management
For efficient management, the FGSW-2620CS is equipped with remote Web interface. It can be programmed for advanced switch management functions such as port configuration, Port-Based / IEEE 802.1Q / MTU VLAN, port mirroring, port trunk, QoS, bandwidth control, broadcast storm control, STP, RSTP, configuration backup/recovery, MAC address / TCP & UDP filter and IGMP Snooping v1/v2.
The FGSW-2620CS provides Port-Based / IEEE 802.1Q / MTU VLAN (port based / IEEE 802.1Q VLAN including overlapping). The VLAN groups allowed on the FGSW-2620CS will be maximally up to 26 for port based or up to 32 for IEEE 802.1Q VLAN groups. On the other hand, the MTU VLAN divides port 1 to port 24 as separate LAN group and only can access the public port 25 / 26 or port 26. Via supporting port trunking, the FGSW-2620CS allows the operation of a high-speed trunk combining multiple ports. The FGSW-2620CS also provides two groups of up to 4-Port 10/ 100Base-TX trunk support with up to 800Mbps bandwidth per trunk and 1 group of 2-Port 10/100/1000Mbps trunk support with up to 2000Mbps bandwidth per trunk, and supports fail-over as well.
Easy Long Distance Installation
The FGSW-2620CS is equipped with the MDI/MDI-X auto detection for easy plug and play connection, regardless of cabling types in straight through or crossover. In addition, with its Auto-Negotiation capability, all the RJ-45/UTP ports of the FGSW-2620CS can be configured to speeds of 10/20Mbps / 100/200Mbps (Fast Ethernet) and 1000/2000Mbps (Gigabit Ethernet) automatically.
The two Gigabit combo ports of the FGSW-2620CS can be either 1000Base-T for 10/100/1000Mbps or 1000Base-SX/LX through SFP (Small Form Factor Pluggable) interfaces. The distance can be extended from 100 meters (TP), 550 meters (Multi-mode fiber), up to above 10/20/30/40/50/70/120 kilometers (Single-mode fiber).
Workgroup Switch
With 24 10/100Mbps ports and up to 2 copper or Gigabit Ethernet fiber ports, the FGSW-2620CS provides a cost-effective, high-performance solution for power users. Department Switch
The FGSW-2620CS can easily build a local, high bandwidth Fast Ethernet network for backbone of your department by performing 8.8 Gigabits per second, non-blocking switch fabric. With the two built-in SFP ports, the FGSW-2620CS provides the uplink to the backbone network through Gigabit Ethernet LX/SX SFP modules.
Physical Port
• 24 x 10/100Base-TX Fast Ethernet ports • 2 x 10/100/1000Base-T TP ports • 2 x 1000Base-X SFP slots, shared with Port-25 and Port-26
Layer 2 Features
• Auto-MDI/MDI-X detection on each RJ-45 port • Prevents packet loss with back pressure (half-duplex) and IEEE 802.3x PAUSE frame flow control (full-duplex) • High performance Store and Forward architecture, runt/CRC filtering eliminates erroneous packets to optimize the network bandwidth • Supports VLAN –IEEE 802.1Q Tag-Based VLAN –Port-Based VLAN –MTU VLAN (Multi-Tenant Unit VLAN) • Supports Spanning Tree Protocol –STP, IEEE802.1D (Classic Spanning Tree Protocol) –RSTP, IEEE802.1W (Rapid Spanning Tree Protocol) –Loopback Detection • Supports Link Aggregation –up to 3 trunk groups –up to 4 Fast Ethernet ports or 2 Gigabit ports per trunk group –IEEE 802.3ad LACP (Link Aggregation Control Protocol) –Cisco ether-channel (Static Trunk) • Port Mirroring to monitor the incoming or outgoing traffic on a particular port
Quality of Service
• 2 priority queues on all Switch ports • Traffic classification –Port-Based priority –IEEE 802.1p based priority –IP TOS / DSCP based priority –TCP / UDP Port-Based QoS • Strict priority and Weighted Round Robin (WRR) CoS policies • In/Out rate limit control on each port • Broadcast Storm Control support Multicast
• Supports IGMP Snooping v1 and v2
Security
• MAC address filter • TCP & UDP filter on each port • Management idle time security
Management
• Remote Web interface for Switch management and setup • Supports SNMP v1 • Supports DHCP Option82 and DHCP Relay • Firmware upgrade through Web interface • Configuration upload / download through Web interface • Reset button for system reboot or reset to factory default • PLANET Smart Discovery Utility for deploy management
Hardware Specification |
Hardware Version |
Version 2 |
10/100Mbps Copper Ports |
24 x 10/100Base-TX RJ-45 Auto-MDI/MDI-X interfaces |
1000Mbps Copper Ports |
2 x 10/100/1000Base-T RJ-45 Auto-MDI/MDI-X ports |
SFP / mini-GBIC Slots |
2 x 1000Base-SX/LX/BX SFP slots, shared with Port-25 and Port-26 |
Switch Processing Scheme |
Store-and-Forward |
Switch Fabric |
8.8Gbps |
Switch Throughput |
6.547Mpps@64Bytes |
Address Table |
4K entries |
Share Data Buffer |
2.75Mb embedded memory for packet buffers |
Flow Control |
Back pressure for half duplex IEEE 802.3x Pause Frame for full duplex
|
Dimension (W x D x H) |
440 x 120 x 44 mm (1U height) |
LED |
Power LNK / ACT (Green) 100/1000 (Green)
|
Reset Button |
< 5 sec: System reboot > 10 sec: Factory Default
|
Weight |
1.61 kg |
Power Requirement |
100~240V AC, 50-60 Hz, 0.5A |
Power Consumption / Dissipation |
19.6 Watts / 66.9BTU |
Smart Function |
System Configuration |
Web interface, SNMP v1 |
Port Configuration |
Port speed duplex mode selection Flow control disable / enable Port disable / enable Port description on each port
|
Bandwidth Control |
1 / 2 / 4 / 8 / 16 / 32 / 64Mbps |
Broadcast Storm Control |
5% / 10% / 25% / 50% / Disable |
Port Statistics |
Display detail Ethernet traffic counter information on each port |
VLAN |
- 32 IEEE 802.1Q VLAN groups
- 26 Port-Based VLAN groups - MTU VLAN
|
Spanning Tree Protocol |
- STP, IEEE 802.1D (Spanning Tree Protocol) - RSTP, IEEE 802.1w (Rapid Spanning Tree Protocol)
|
Link Aggregation |
- 2 groups of 4-Port 10/100Base-TX trunk support, up to 800Mbps bandwidth per trunk - 1 group of 2-Port 10/100/1000Mbps trunk support, up to 2000Mbps bandwidth per trunk
|
Port Mirroring |
Port mirroring allows monitoring of the traffic across any port in real time |
QoS |
Allows to assign low / high priority on each port First-In-First-Out, All-High-before-Low, Weight-Round-Robin QoS policy
|
Security |
MAC Address TCP & UDP Filter
|
IGMP Snooping v1 / v2 |
Allows to disable or enable |
Standards Conformance |
Regulation Compliance |
FCC Part 15 Class A, CE |
Standards Compliance |
IEEE 802.3 (Ethernet)
IEEE 802.3u (Fast Ethernet) IEEE 802.3ab (Gigabit Ethernet) IEEE 802.3z (Gigabit Ethernet) IEEE 802.3x (Full-Duplex Flow Control) IEEE 802.1Q VLAN IEEE 802.1p QoS IEEE 802.1D (Spanning Tree Protocol) IEEE 802.1w (Rapid Spanning Tree Protocol)
|
Environment |
Temperature |
Operating: 0~50 Degree C Storage: -10~70 Degree C
|
Humidity |
Operating: 5~90%, Storage: 5~90% (Non-condensing) |
|